Web Hosting by Netfirms | Free Domain Names by Netfirms

1. Drivers must be 14 years of age or older. Those under 18 years of age must have written parental/guardian permission.

2. Drivers must stay on the seat of the tractor at all times. Hands must be on the steering wheel, hand brakes, hand clutch, or throttle at all times during the pull.

3. Any tractor or puller found to be unsafe or illegal may be disqualified or barred from hooking. No alcoholic beverage will be permitted. 

4. Any part falling off while hooked to the sled will result in DQ.

5. Sled & tractor must stay in bounds at all times.

6. Any tractor can pull in a maximum of 2 classes. One hook per class. This is subject to change.

7. Wheelie bars are required. All tractors must have a working safety kill switch.

8. Draw bars must not exceed 20 inches in height and must be at least 18 inches from the center of the axle to the hooking point. No part of the draw bar may extend rearward beyond point of hook. Draw bars must be stationary in all directions. NO CLEVISES.

9. Weights must not extend rearward beyond rear tires and cannot be more than 11 feet from the center of the rear axle to the furthest point forward. Stock wheel base cannot be altered.

10. No radial tires. No steel wheels. Two-wheel drive only. NO DUALS.

11. MANDATORY fan guards on all tractors (side Shield or fan shield).

12. Tractors must be naturally aspirated.

13. Gas, diesel, or LP fuel only. No alcohol or nitrous oxide fuels may be used. Gas is allowed a maximum of 750 specific gravity. All tractors are subject to random fuel checks. Tractors manufactured to use diesel fuel only cannot be converted to gas or LP.

14. Any agricultural type carburetor is allowed. Must be the same number of barrels and throats and draft direction as the originally manufactured. Electric fuel pumps allowed.

15. R.p.m.'s allowed will be determined by M&W chart. Any tractor not listed will use manufacturer's data. 20% margin of error will be permitted in all classes.

16. Enhanced electrical systems permitted in all classes. No rev limiters allowed.

17. Tractors must have stock frame, transmission, rear axle and axle housing or manufacturer's replacement. 

18. Heads, blocks (jugs), manifolds must be the same manufacturer and material as the crankcase and frame. (Manufacturer replacements allowed)

19. Spacer plates and girdles will have no more than 1 inch above and 1 inch below the center line of the crank shaft. 2 inches total.

20. Super Farm Stock Class Only: Oliver 88, Farmall M, Massey 44, MM-U, JD-G, Case-C/D, JD-A and up, and like size tractors are not allowed in classes below 4500#. Massey 33, Oliver 77 and down, and like size tractors are not allowed in classes below 4000#. 

THE JUDGE'S DECISION IS FINAL AT ALL TIMES DURING THE PULL!